ITech IT7300 Series - Config:bnc[:Port][:Function]; Config:dimmer:mode; Config:list:start:mode

Configuration Commands
Copyright © Itech Electronic Co., Ltd. 22
Example
conf:prot:curr:peak:mod imm
Query syntax
CONFig:PROTect:CURRent:PEAK:MODe?
CONFig:BNC[:PORT][:FUNCtion]
This command is used to set the function of BNC terminal. The command
function is the same as BNC-Set in the instrument panel menu.
Command syntax
CONFig:BNC[:PORT][:FUNCtion]
Parameters
I-TRigger|I-RI|O-PHase|O-ON
Example
CONF:BNC I-RI
Query syntax
CONFig:BNC[:PORT][:FUNCtion]?
CONFig:DIMMer:MODe
The command is used to configure the phase dimming mode: leading/trailing
edge dimming. This command function is equivalent to Dimmer in the
instrument panel menu.
Command syntax
CONFig:DIMMer:MODe
Parameters
LEADingedge|TRAilingedge|OFF
Example
conf:dimm:mod lead
Query syntax
CONFig:DIMMer:MODe?
CONFig:LIST:STARt:MODe
This command is used to set the mode that LIST starts to run. The command
function is equivalent to the configuration menu to set List-Set.