ITech IT7300 Series Programming Guide

List Operation Commands
Copyright © Itech Electronic Co., Ltd. 38
Chapter10 List Operation Commands
LIST:STATe
This command is used to set the state of list mode.
Command syntax
LIST:STATe
Parameters
DISable|ENABle
Query syntax
LIST:STATe?
Returns
DISable|ENABle
LIST:RECall
This command is used to recall a list file.
Command syntax
LIST:RECall <NR1>
Parameters
0~9
Example
LIST:REC 6
LIST:STEP:COUNt
This command sets the number of steps in list file.
Command syntax
LIST:STEP:COUNt
Parameters
1~100
Example
LIST:STEP:COUN 12

ITech IT7300 Series Specifications

General

Brand	ITech
Model	IT7300 Series
Category	Power Supply
Language	English