List Operation Commands
Copyright © Itech Electronic Co., Ltd. 43
Parameter 2
Status, off|on|0|1
Example
LIST:STEP:SD:CONT 3,on
Query syntax
LIST:STEP:SD:CONTinue?
Parameters
Number of steps, 0 ~ 99
LIST:STEP:SD:VOLTage
This command is used to set the surge / notch voltage of the LIST single-step.
Command syntax
LIST:STEP:SD:VOLTage
Parameter 1
Number of steps, 0 ~ 99
Parameter 2
Surge / Notch Voltage, Float
Example
LIST:STEP:SD:VOLT 3,120
Query syntax
LIST:STEP:SD:VOLTage?
Parameters
Number of steps, 0 ~ 99
LIST:STEP:SD:SITe
This command is used to set the start position of the surge / notch for the LIST
single-step. Parameters 1 and 2 are mandatory.
Command syntax
LIST:STEP:SD:SITe
Parameter 1
Number of steps, 0 ~ 99
To Next Page
Loading...
