ITech IT7300 Series - Config:measure:current:mode; Config:measure:current:range; [Source:]Protection:clear

Configuration Commands
Copyright © Itech Electronic Co., Ltd. 23
Command syntax
CONFig:LIST:STARt:MODe
Parameters
ON/OFF|TRIGGER
Query syntax
CONFig:LIST:STARt:MODe?
CONFig:MEASure:CURRent:MODe
This command is used to set the current measurement mode, you can choose
automatic or manual mode to measure the current.
Command syntax
CONFig:MEASure:CURRent:MODe
Parameters
AUTO|MANUal
Query syntax
CONFig:MEASure:CURRent:MODe?
CONFig:MEASure:CURRent:RANGe
This command is used to set the current measurement range: High range,
Middle range or Low range when the Manual mode is chosen.
Command syntax
CONFig:MEASure:CURRent:RANGe
Parameters
LOW|MIDDle|HIGH
Query syntax
CONFig:MEASure:CURRent:RANGe?
[SOURce:]PROTection:CLEar
This command is used to clear the protection status. Before that, you need to
remove the cause of protection.
Command syntax
[SOURce:]PROTection:CLEar