ITech IT7300 Series - Chapter6 Remote Operation Mode; Communication Interfaces (RS232, USB, LAN, GPIB)

TRACe Subsystem Commands
Copyright © Itech Electronic Co., Ltd. 32
Example
TRAC:DEL 1
Query syntax
TRACe:DELay? [MINimum | MAXimum | DEFault]
Returns
<NR3>
TRACe:TIMer
This command is used to set the time interval between two adjacent storage
operations, such as the time interval between the second point value and the
third point value.
Command syntax
TRACe:TIMer <NRf>
Parameters
0.00002 to 3600s | MINimum | MAXimum | DEFault
UNIT
S (second)
Example
TRAC:TIM 0.1
Query syntax
TRACe:TIMer? [MINimum | MAXimum | DEFault]
Returns
<NR3>
TRACe:DATA?
This command is used to read the readings stored in the cache and return
these values to the PC interface.
Before sending this command, you must ensure that the cache function is
enabled (i.e. TRAC:FEED:CONT NEXT has been executed), and the data
buffer of the IT7300 has data storage. Otherwise, the system will report an error
by directly running the TRACe:DATA? command.
Query syntax
TRACe:DATA?