ITech IT7300 Series Programming Guide

System Commands
Copyright © Itech Electronic Co., Ltd. 17
Returns
<NR1>
Related commands
STATus:OPERation:ENABle
Description of the register:
Bit 7 6 5 4 3 2 1 0
Name N N N N WTRG SWEEP LIST CAL
Value 8 4 2 1
STATus:OPERation:CONDition?
This command can read the parameter from the operation condition register.
When the parameter of operation condition register changes, the bit
corresponding in operation event register is 1.
Query syntax
STATus:OPERation:CONDition?
Parameters
None
Returns
<NR1>
STATus:OPERation:ENABle
This command can set the parameter of operation event enable register.
Setting parameter can determine which bit value of operation event register is 1
and the bit will cause OPER of status byte register to be 1.
Command syntax
STATus:OPERation:ENABle <NR1>
Parameters
0~255
Example
STATus:OPERation:ENABle 128
Query syntax
STATus:OPERation:ENABle?

ITech IT7300 Series Specifications

General

Brand	ITech
Model	IT7300 Series
Category	Power Supply
Language	English