ITech IT7300 Series Programming Guide

Configuration Commands
Copyright © Itech Electronic Co., Ltd. 20
Parameters
MINimum|MAXimum|Float
Example
CONF:FREQ:MIN 60
Query syntax
CONFig[:SOURce]:FREQuency:MINimum?
CONFig[:SOURce]:FREQuency:MAXimum
This command is used to configure the frequency upper limit, same as
Freq-Max in the instrument panel menu.
Command syntax
CONFig[:SOURce]:FREQuency:MAXimum
Parameters
MINimum|MAXimum|Float
Example
CONF:FREQ:MAX 400
Query syntax
CONFig[:SOURce]:FREQuency:MAXimum?
CONFig:PROTect:CURRent:RMS
This command is used to configure the current rms protection point. This
command is equivalent to Irms-Protect in the front panel menu of the
instrument.
Command syntax
CONFig:PROTect:CURRent:RMS
Parameters
MINimum|MAXimum|Float
Example
CONF:PROT:CURR:RMS 2
Query syntax
CONFig:PROTect:CURRent:RMS?

ITech IT7300 Series Specifications

General

Brand	ITech
Model	IT7300 Series
Category	Power Supply
Language	English