Reset of measurement data
End of current data saving
Recorded each time new configuration parameters have
been programmed into the meter.
AC_FAIL_APPEARANCE
AC_FAIL_DISAPPEARANCE
Recorded when a micro power failure (<=1 second) is
detected by the meter, at the same time the state of power
supply backup is checked.
Recorded when the meter cut calculation reaches the
lower threshold, all meter data is then saved.
11.2. Alarm descriptions
The following table contains a list of alarms (these may change due to meter firmware revision):
Watchdog
(see note 1 below)
EXTERNAL CLOCK INCOHERENCE
Meter clock programming error
(see note 2 below)
CONFIGURATION INCOHERENCE
Incoherence of configuration parameters
(see note 3 below)
NON VOLATILE MEMORY NON FATAL
ERROR
Checksum error in Flash memory
(see note 1 below)
Incoherence of parameters programmed
(see note 4 below)
Detection of abnormal use of terminal cover
No internal energy consumed for more than n days
Incoherence of internal clock after power cut
(see note 5 below)
To Next Page
Loading...
Need help?
General
