3.1. Applicable standards
The ACE6000 meters comply, where applicable, with the following standards and regulations.
IEC 62052-11 Electricity metering equipment (AC) - General requirements, tests and test conditions, part 11:
Metering equipment (equivalent to EN 6205-11)
IEC 62053-21 Electricity metering equipment (AC) - Particular requirements, part 21: Static meters for active
energy (classes 1 and 2), (equivalent to EN 62053-21)
IEC 62053-22 Electricity metering equipment (AC) - Particular requirements, part 22: Static meters for active
energy (classes 0,2 S and 0,5 S)
IEC 62053-23 Electricity metering equipment (AC) - Particular requirements, part 23: Static meters for
reactive energy (classes 2 and 3)
IEC 62053-31 Electricity metering equipment (AC) - Particular requirements, part 31: Pulse output devices
for electro-mechanical and electronic meters (equivalent to EN 62053-31)
IEC 62053-52 Electricity metering equipment (AC) - Particular requirements, part 52: Symbols
IEC 62053-61 Electricity metering equipment (AC) - Particular requirements, part 61: Power Consumption
and Voltage Requirements
IEC 62054-21 Electricity metering equipment (AC) - Tariff Load control, part 21: Particular requirements for
time switches (equivalent to EN62054-21)
IEC 62056-21 Electricity Metering – Data exchange for meter reading, tariff and load control - Direct local
data exchange (supersedes IEC61107)
IEC 62056-42 Electricity Metering – Data exchange for meter reading, tariff and load control, part 42:
Physical layer services and procedures for connection-oriented asynchronous data exchange
IEC 62056-46 Electricity Metering – Data exchange for meter reading, tariff and load control, part 46: Data
link layer using HDLC protocol
IEC 62056-47 Electricity Metering – Data exchange for meter reading, tariff and load control, part 47:
COSEM transport layers for IPv4 networks
IEC 62056-53 Electricity Metering – Data exchange for meter reading, tariff and load control, part 53:
COSEM Application layer
IEC 62056-61 Electricity Metering – Data exchange for meter reading, tariff and load control, part 61: Object
identification system (OBIS)
IEC 62056-62 Electricity Metering – Data exchange for meter reading, tariff and load control, part 62:
Interface classes
European Directive 2004/22/EC for Measurement Instrument Directive (MID)
The HF resistance is relative to the frequency domain from 2kHz to 150kHz, the immunity levels are far in excess
of the values generated by LV loads.
The following outline the approval standards in the regulated frequency ranges which all Itron MID approved
meters comply with:
EN61000-3-2 – Defines the harmonic range 100Hz - 2kHz
EN61000-4-6 – Defines resistance against conducted perturbations induced by radio-electrical fields >
150kHz
EN55022/CISPR22 – Defines (ClassB) radio-electrical conducted emissions in the range > 150kHz
To Next Page
Loading...
Need help?
General
