Need help?Do you have a question about the ITRON Gen 5 500W ERT and is the answer not in the manual?
General| Brand | ITRON |
|---|---|
| Model | Gen 5 500W ERT |
| Category | Control Unit |
| Language | English |
Details module compliance, part numbers, and general capabilities.
Lists other useful documents for reference and further information.
Explains how modules join a Gen5 network and communicate with the head end.
States the module is IPv6 Wi-SUN compliant, operating in network or mobile mode.
Details intervals, storage, and reporting capabilities in network mode.
Explains transmissions in mobile mode and the data reported.
Lists and describes factory, audit, run, and quiet modes.
Discusses expected battery life and low battery indicators.
Introduces common events and alarms for the module in network mode.
Lists module firmware versions and their associated features.
Covers considerations and methods for programming the 500W ERT Module.
Details wire color mapping for connecting to encoder-type registers.
Details wire color mapping for connecting to pulser-type registers.
Information on ordering and using extension cables for the module.
Procedures for verifying module operation using programming devices.
Steps and materials for installing cable strain relief on the module cable.
Instructions for attaching the 500W ERT Module backplate.
Steps for mounting the module remotely from the register.
Lists available mounting accessories and their part numbers.
Specific steps for direct mounting on ABB Scancoder, InVision, or Digital meters.
Specific steps for direct mounting on Badger ADE and RTR meters.
Instructions for mounting the module on a pipe using kits.
Shows adapter plate positions for different pipe angles.
Steps to attach the module to the adapter plate.
Steps for mounting the module on a flat surface.
Instructions for installing the SET Remote Disconnect Valve.
Details wire color mapping for the disconnect valve.
Instructions for installing the Leak Sensor with the module.
Procedure for installing Itron cable armor for cable protection.
Steps for using the crimping tool and connector.
Steps for immersing connectors in the splice tube gel.
Table detailing common issues and their resolutions.
Lists event IDs, names, and descriptions for network mode.
FCC compliance statement and operating conditions.
FCC Class B digital device compliance and interference mitigation.
Canadian ISED compliance statement and regulations.
RF exposure limits and installation guidelines.
Australian ACMA compliance for radio, EMC, and RF.
Note about RCM approval for New Zealand.
Warnings and procedures for handling lithium batteries.
Safety warning for qualified technicians regarding power disconnection.
Warning about using approved accessories and modifications.
Warning about ESD sensitivity and prevention measures.
Warning about dropping the module and potential warranty void.
To Next Page
