Chapter 3 Installing the Intelis Gas Meter
This section provides the Intelis Gas Meter installation information.
Warning: This product, as of the date of its manufacture, is designed and tested to
conform to all governmental or industry safety standards then existing as they may
apply to the manufacturer. The purchaser and user of this product are warned that
compliance with all country, state, and local codes required in order to avoid the
hazards of leaking gas resulting from improper installation, start-up, or use of this
product, and further, that all fire control, building codes, or other safety regulations
established under public laws which regulate or govern the application, installation,
operation, or general use of this product, should be complied with. In order to ensure
the safe and proper operation of this product, the manufacturer recommends that a
qualified technician install this product.
The Intelis Gas Meter must be installed with the inlet to the left, the outlet to
the right, the meter in a horizontal position and with the LCD facing out. INLET
and a flow arrow are marked on the Intelis Gas Meter casing.
Note: These instructions assume the gas is turned of
f, the previous gas meter is
removed (when the Intelis Gas Meter is replacing an existing installation), piping
tests are completed, and all safety requirements are met.
Intelis Gas Meter Installation Guide TDC-1782-002 11
Proprietary and Confidential
To Next Page
Loading...
Need help?
General
