Product notification
Warning: These instructions are not intended to replace any utility or company-
established meter installation procedures. These instructions are provided for
additional information when the Intelis Gas Meter is installed. The meter installation
must comply with all country, state, and local building and safety regulations as well
as federal regulations including Section 192.353 of Title 49 of the Code of Federal
Regulations. Two pertinent paragraphs of the code are:
• Each meter and service regulator, whether inside or outside of a building must be
in a readily accessible location and be protected from corrosion and other
damage.
• Each meter installed within a building must be located in a ventilated place and
not less than 3 feet from any source of ignition or any source of heat which might
damage the meter.
The Intelis Gas Meter is rated for the following operating and storage temperature
ranges. Use of the meter outside of the listed temperature ranges is not
recommended.
• Operating ranges:
◦ Measurement -30° F (-34° C) to +131° F (55° C)
◦ Valve -13° F (-25° C) to +131° F (55° C)
◦ 500G -40° F (-40° C) to +158° F (70° C)
• Storage range:
◦ -40° F (-40° C) to +158° F (70° C)
Direct customer inquiries as to the selection and application of gas meters to your
local Itron sales representative or Itron Support.
• Itron does not endorse or warrant the completeness or accuracy of any third-party
meter installation procedures or practices, unless otherwise provided in writing by
Itron.
• Follow your company's standard operating procedures regarding the use of
personal protection equipment (PPE).
• Adhere to guidelines issued by your company in addition to those given in this
document when installing or repairing meters.
• This product, as of the date of manufacture, is designed and tested to conform to
all governmental and industry safety standards as they may apply to the
manufacturer.
• The purchaser and user of this product must comply with all fire control, building
codes, and other safety regulations governing the application, installation,
operation, and general use of this meter to avoid leaking gas hazards resulting
from improper installation, start-up, or use of this product.
• To ensure safe and efficient operation of this product, Itron strongly recommends
installation by a qualified professional.
Important Safety and Compliance Information
Intelis Gas Meter Installation Guide TDC-1782-002 5
Proprietary and Confidential
To Next Page
Loading...
Need help?
General
