Note: The rod shown has an end cap to protect the rod while driving it into the ground.
5. Drive the rod into the ground so the top of the rod is approximately 3-1/2 inches below
the bottom of the pit lid.
• If you cannot drive the rod in enough to equal the necessary spacing, cut the
remaining rod length to the proper height using an abrasive cut-of
f tool.
Caution:
Cutting fiberglass creates dust particles. Practice proper safety
precautions when using cut-off tools to prevent exposure to fiberglass dust
particles.
• If the rod is the correct depth but remains loose in the soil, replace the rod with a
longer version.
6. The top of the rod must be 3-1/2 inches below the bottom of the lid. Place the Riva
module on the rod. Completely insert the rod into the pit module's rod mount hole. Do not
force the pit module onto the rod. If the pit module does not slide freely on the rod,
remove the pit module and examine the pit module rod hole and rod for burrs or
obstructions.
Installing the OpenWay Riva Water Pit Module
OpenWay Riva Water Pit Module Installation Guide TDC-1743-004 20
Proprietary and Confidential
To Next Page
Loading...
