Editing Milling Jobs
105
Operating the material and tool changer via the main menu [Service]
You are in the main menu [Service].
The material and tool changer is not active.
1. Select the sub-menu [Blocks]
2. In the list of blocks, tap on the position
of your choice.
The material and tool changer will be brought into position and the block holder
containing the block will be provided at the loading aid.
You can remove the block (“Removing the block from the device via the loading aid”,
page 106).
The app shows a Wizard which will guide you step by step through the removal process.
To Next Page
Loading...