Editing Milling Jobs
94
6. Start manual identification of the tool in the menu [ToDo] (e.g. faster start of milling job
possible in the Single mode).
– or –
Have the tool automatically identified by the machine (e.g. if several tools are inserted in
the Multi mode).
The tool is identified / scanned, indicated by the symbol in the app (for symbol description
see “Status displays in the section [Tools]”, page 70).
If the tool has been successfully identified or an error occurred, the symbol changes
accordingly.
In case of an unsuccessful identification, you can manually register the tool in the app.
In the event of a failed identification, additional information on troubleshooting can be
found in section:
• “Troubleshooting / error table”, page 117
• “Manually registering a non-identified tool”, page 123
To Next Page
Loading...