CUTTING UNITS
4181384 First Edition 8-11
8
Streaks
NOTE: Arrow indicates direction of travel.
A streak is a line of uncut grass. This is usually caused by
a damaged blade.
Probable Cause Remedy
Damaged blade(s). Replace blade(s). (See “Cutter Blade” on page 8-28.)
Turning too aggressively. Cutting units don’t overlap during turns
or on side hills.
Turn less aggressively to allow cutting units to overlap. Change
mowing direction or pattern on side hills.
Tire mats down grass before it is cut. Check/adjust tire inflation pressure. (Refer to “Safety, Operation,
and Maintenance Manual.”)
Wet grass is matted down before it is cut. Cut when grass is dry.
TN0224
To Next Page
Loading...
