EasyManua.ls Logo

Jandy Stealth SHPF.50 - Section 1. IMPORTANT SAFETY; Instructions; Safety Instructions

Jandy Stealth SHPF.50
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 1. IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Safety Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
Page 3
ENGLISH
Jandy
®
Stealth
Pumps
|
Operation Manual
WARNING
To reduce the risk of injury, do not permit children to use this product.
WARNING
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
ow)valvepositionwiththepumprunning.
WARNING
Jandypumpsarepoweredbyahighvoltageelectricmotorandmustbeinstalledbyalicensedorcertiedelec-
tricianoraqualiedswimmingpoolservicetechnician.
WARNING
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH (For all permanently installed units
intended for use on 15 or 20 ampere, 120 through 240 volt, single phase branch circuits). Connect only
toabranchcircuitthatisprotectedbyaground-faultcircuit-interrupter(GFCI).Contactaqualiedelectricianif
you cannot verify that the circuit is protected by a GFCI. A GFCI should be provided by the installer and should
be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the
reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the
GFCIinterruptspowertothepumpwithoutthetestbuttonbeingpushed,agroundcurrentisowing,indicating
the possibility of electrical shock. Do not use the pump. Disconnect the pump and have the problem corrected by
aqualiedservicerepresentativebeforeusing.
Duetothepotentialriskofre,electricshock,orinjuriestopersons,JandyPumpsmustbeinstalledinaccor-
dance with the National Electrical Code
®
(NEC
®
),alllocalelectricalandsafetycodes,andtheOccupationalSafe-
ty and Health Act (OSHA
®
).CopiesoftheNECmaybeorderedfromtheNationalFireProtectionAssociation
®
(NFPA
®
)onlineatwww.nfpa.orgorcall617-770-3000,orcontactyourlocalgovernmentinspectionagency.
WARNING
Incorrectly installed equipment may fail, causing severe injury or property damage.
WARNING
Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
Trappedairinsystemcancausethelterlidtobeblownoff,whichcanresultindeath,seriouspersonalinjury,
or property damage. Be sure all air is out of the system before operating.
WARNING
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use this pump for wading
pools, shallow pools or spas containing bottom drains, unless the pump is connected to at least two functioning
suctionoutlets.Suctionoutlet(drain)assembliesandcoversmustbecertifiedtothelatestpublishedversionof
ANSI
®
/ASME
®
A112.19.8, or its successor standard, ANSI/APSP-16.

Table of Contents

Related product manuals