Janome HD9 - Knee Lifter Lever

10
7 to 8 mm
13. Knee Lifter Lever
The presser foot rises 7 to 8 mm when it is fully raised
with the knee lifter.
Remove the base and lay the machine on its back.
Loosen the nut
q
on the knee lifter lever
w
slightly
and turn the adjusting screw
e
to adjust the height.
• If it is lower than 7 to 8 mm, turn the adjusting screw
e
clockwise.
• If it is higher than 7 to 8 mm, turn the adjusting screw
e
counterclockwise.
Tighten the nut
q
firmly and attach the base.
NOTE:
Lower the needle bar to the lowest position and check
if the needle cramp does not hit against the presser foot
when it is fully raised.
z
x
c
q
w
e