Janome HD9 - External Parts Replacement Guide; Face Plate Removal and Replacement; Top Cover Removal and Installation; Base Removal and Reattachment

1
Remove the setscrews (4x25)
r
.
Lift the top cover
t
and pull out the motor
connector
y
. Remove the top cover.
Replacing the External Parts
1. Face Plate
Remove the setscrew (4x10)
q
and washer
w
.
Remove the face plate
e
.
2. Top Cover
3. Belt Cover
Remove the 3 setscrews (4x12)
u
and the belt
cover
i
.
Pull out the socket connector
!7
from the printed
circuit board UD connector
!8
.
NOTE:
When attaching the belt cover, engage the hooks
with the motor cover.
4. Motor Cover
Remove the 2 setscrews (4x16)
o
,
setscrew (4x12)
!0
and remove the motor
cover
!1
.
5. Base
Remove the 4 hinge screws
!2
, washers
!3
,
rubber feet
!4
and base washers
!5
.
Remove the base
!6
.
To attach:
Follow the above procedures in reverse.
q
w
e
r
r
t
y
u
u
i
o
!0
!0
!3
!2
!2
!4
!5
!1
!6
!7
!8