Janome MC6600 - TO REMOVE CIRCUIT BOARD F AND SLIDE VOLUME

CS RING
SLIDE VOLUME
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
SETSCREW A
CONNECTOR
TO REMOVE CIRCUIT BOARD F AND SLIDE VOLUME
CIRCUIT BOARD F
CS RING
[TO REMOVE THE CIRCUIT BOARD F]
1. REMOVE THE FRONT COVER (REFER TO PAGE
4)
2. PULL OUT THE CONNECTOR FROM THE CIRCUIT
BOARD A.
3. REMOVE THE 4 SETSCREWS (A), 2 CS RINGS
AND CIRCUIT BOARD F.
[TO ATTACH]
REVERSE THE ABOVE PROCEDURE.
MAKE SURE THAT THE BUTTONS ARE PLACED IN
THE CORRECT PLACES AND DIRECTION (FIG. 1).
[TO REMOVE THE SLIDE VOLUME]
1. REMOVE THE FRONT COVER (REFER TO PAGE
4)
2. PULL OUT THE CONNECTOR FROM THE CIRCUIT
BOARD K.
3. REMOVE THE 2 CS RINGS AND SLIDE VOLUME.
[TO ATTACH]
REVERSE THE ABOVE PROCEDURE.
9