Janome MC6600 - TO REMOVE FRONT COVER

1 REMOVE THE FACE PLATE, TOP COVER AND BELT
COVER (REFER TO PAGES 1 AND 2).
2 LOOSEN THE SETSCREWS (A), (B), (C) AND (D).
3 PULL OUT THE CONNECTORS (REFER TO
PAGE 22) AND REMOVE THE FRONT COVER.
4 REMOVE THE NYLON CLIP FROM THE UPPER
LEFT SIDE OF THE TENSION RELEASE MOTOR.
5 PULL OUT THE CONNECTORS FROM THE
PRINTED CIRCUITBOARD K.
[TO ATTACH]
6 PROCEED WITH THE ABOVE PROCEDURE IN
REVERSE.
SETSCREW (A)
SETSCREW (C)
TO REMOVE FRONT COVER
[TO REMOVE]
SETSCREW (B)
SETSCREW (D)
FRONT
COVER
[VIEW FROM BELT COVER SIDE]
[VIEW FROM FACE PLATE SIDE]
INSULATION PAPER
CORDS
WHEN ATTACHING THE FRONT COVER, ENSURE THAT
THE CORDS SHOWN IN THE PHOTO ON THE LEFT
DO NOT GET CAUGHT BETWEEN THE COVER AND
THE PARTS.
4