Janome MC6600 - TO ADJUST BUTTONHOLE LEVER POSITION

TO ADJUST BUTTONHOLE LEVER POSITION
1 WHILE PRESSING THE NEEDLE UP/DOWN AND
LOCK STITCH KEYS, TURN THE POWER
SWITCH ON. PRESS THE NUMBER ì4î BUTTON
WITHIN 3 SECONDS.
2 REMOVE THE FACE PLATE (REFER TO PAGE 1).
LOWER THE BUTTONHOLE LEVER (C).
3 LOOSEN THE SETSCREW (A) AND MOVE THE
BUTTONHOLE LEVER GUIDE (B) UNTIL THE DIS
PLAY SHOWS ìSENSOR Lî.
4 ATTACH THE BUTTONHOLE FOOT (R).
5 ADJUST THE CLEARANCE OF THE BUTTON-
HOLE FOOT TO 1.6 MM (D).
6 LOOSEN THE SCREW (E) UNTIL THE DISPLAY
SHOWS ìSENSOR Hî.
7 TIGHTEN THE SCREW (E) UNTIL THE DISPLAY
JUST CHANGES FROM ìSENSOR Hî TO
ìSENSOR Lî.
8 TURN OFF THE POWER SWITCH.
9 ATTACH THE FACE PLATE.
BUTTONHOLE LEVER (C)
SETSCREW
(A)
CLEARANCE
(D) 1.6 MM
SCREW
(E)
BUTTONHOLE
LEVER GUIDE (B)
BUTTONHOLE FOOT (R)
36
1.6 MM
(Thickness of the Gauge 860G002)