Step3
Switch
SP FL CL DD
UPOFFUPOFF
TD
OFF
TO ADJUST THE AUTO THREAD CUTTER SWITCH POSITION
1 WHILE PRESSING THE NEEDLE UP/DOWN AND
LOCK STITCH BUTTONS, TURN THE POWER SWITCH
ON. PRESS THE NUMBER ì9î BUTTON WITHIN
3 SECONDS.
2 REMOVE THE MACHINE BASE AND AUTO THREAD
CUTTER COVER (REFER TO PAGES 2 AND 3).
3 SET THE NEEDLE BAR AT THE LOWEST POSITION.
4 LOOSEN THE SETSCREW (A) AND ADJUST THE
POSITION OF THE SWITCH (B) AS FOLLOWS.
* WHEN THE DRIVING ARM (1) IS LOWERED, THE
DISPLAY (C) SHOWS ìONî.
* WHEN THE DRIVING ARM (1) IS RAISED, THE
DISPLAY (C) SHOWS ìOFFî.
5 ATTACH THE MACHINE BASE AND AUTO THREAD
CUTTER COVER.
DISPLAY (C)
SETSCREW (A)
(SEWING MODE) (CUTTING MODE)
THE DRIVING ARM (1)
IS RAISED.
THE DRIVING ARM (1)
IS LOWERED.
SWITCH (B)
DRIVING ARM (1)
DRIVING ARM (1)
39
To Next Page
Loading...
