Janome MC6600 - TO REPLACE CIRCUIT BOARD A AND FUSE

TO REPLACE CIRCUIT BOARD A AND FUSE
[TO REMOVE]
1 REMOVE THE FRONT COVER
(REFER TO PAGE 4).
2 REMOVE THE 4 SETSCREWS (A).
REMOVE THE CIRCUIT BOARD A TOGETHER
WITH THE MOUNTING BRACKET.
3 REMOVE THE 2 SETSCREWS (B) AND 2 SET
SCREWS (C).
4 REMOVE THE CIRCUIT BOARD CASE AND LID.
[TO ATTACH]
REVERSE THE ABOVE PROCEDURE.
* THE SHINY SIDE OF THE INSULATION PAPER
SHOULD FACE THE CIRCUIT BOARD A.
[TO CHANGE THE FUSE]
1. REMOVE THE 2 SETSCREWS (B) AND
2 SETSCREWS (C).
2. REMOVE THE CIRCUIT BOARD CASE AND LID.
3. PRY THE FUSE OUT WITH A SCREWDRIVER
AS SHOWN.
IF THE FUSE IS LOOSE, BEND THE FUSE
HOLDER WITH YOUR FINGERS.
REPLACE THE FUSE WITH THE SAME PART NUM-
BER AS SHOWN IN THE ILLUSTRATION.
PRINTED CIRCUIT
BOARD A
SETSCREW (A)
SETSCREW (A)
SETSCREW (A)
MOUNTING
BRACKET
INSULATION
PAPER
SETSCREW (B)
SETSCREW (B)
SETSCREW (C)
SETSCREW (A)
A BOARD CASE
LID
SETSCREW (B)
SETSCREW (D)
SETSCREW (D)
(F1) 3.15A
PART NO. 00182904
(F2) 2.5A
PART NO. 000144605
(F2) 2.5A
PART NO. 000144605
SETSCRW (C)
SETSCREW (C)
LID
7