Janome MC9500 - Adjusting Height of Embroidery Foot P

21
MC 9500
Adjusting Height of Embroidery Foot P
1
4
7
2
5
6
4
3
Space between the needle plate and the bottom surface of the Foot (P) should be
1.0 to 1.6 mm, when the needle bar is at its lowest position.
1 Set the pressure dial at “2” and remove the
top cover.
2 Lower the needle bar and lower the presser bar
lifter.
3 Insert the 1.2 mm Thickness gauge between
the Embroidery Foot (P) and the needle plate.
4 While pressing the Pressure bar actuator down
against the upper shaft cam, loosen the Screw (A)
and push it down to the direction of arrow, then
tighten Screw (A) again.
5 Reattach the rear cover.
(Set the Pressure dial at “3”.)
Pressure dial
Thickness gauge
Embroidery foot (P)
Pressure bar actuator
Screw (A)
Needle
Upper shaft
1
2
1
3
4
5
1
2
3
4
6
7
5
5
www.promelectroavtomat.ru