Janome MC9500 - TTP Adjusting Mode

26
MC 9500
SET
PRESS MARK
SET
ADJUSTMENT END
OK
1
3
TTP Adjusting Mode
if a different pattern appears on the touch panel when you pressed the touch panel for
selecting a desired pattern, follow the instructions below.
To adjust touch panel:
1 While pressing the Needle Up/Down button , turn
the power switch “ON” .
(Keep pressing the Needle Up/Down button until the
“PRESS MARK” and ” + “ mark appears.)
Needle Up/Down button
Power switch
Touch panel
2 Press “+ “ mark with the tip of the additional spool pin.
(Press to in order.)
3 When you press the fifth “ + “, “ADJUSTMENT END”
will appear on the touch panel.
4 Turn the power switch “OFF”.
5 Turn the power switch “ON” and check the Touch panel
again.
1
2
1
2
1 5
2
4
5
3
2
1
2
3
3
www.promelectroavtomat.ru