Janome MC9500 - Replacing Carriage Plate (Unit); To remove:; To attach:

33
MC 9500
Replacing Carriage Plate (Unit)
Replace the carriage plate
To remove:
1 Turn the power switch “ON” and select the Embroidery
Mode and select the pattern No.1.
2 Turn the power switch “OFF” and remove the Cover
cap .
(Unlock the Hook from the inside.)
3 Turn the power switch “ON” and return the carriage
to the home position.
4 Remove Screws (3 pieces) and remove the carriage
plate.
To attach:
5 Attach the carriage plate (unit) and tighten Screws
temporarily.
6 Adjust the carriage plate position so that its top surface
is parallel and the same level with the Bed surface .
Tighten the Screws securely.
7 Attach the Cover cap .
Cover cap
Hook
Screws
Bed surface
1
3
1
2
1
2
3
3
4
3
1
2
3
4
3
4
www.promelectroavtomat.ru