25
MC 9500
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Replacing Printed Circuit Board F/Slide Volume
Printed circuit board F
To remove:
1 Remove the front cover. (See page 6)
2 Pull out the Connector from the printed circuit
board A.
3 Remove Screws (2 pieces) and remove
the Printed circuit board F .
To attach:
4 Follow the above procedure in reverse.
(Pass the cords under the ribs as shown.)
Printed circuit bord connector
Screws (2 pieces)
Printed circuit board F
Ribs
2
3
Slide volume
To remove:
1 Remove the front cover. (See page 6)
2 Pull out the Slide volume connector from the
printed circuit board A.
3 Remove the CS ring (2 pieces) and remove the
slide volume.
Slide volume connector
CS ring
To attach:
4 Follow the above procedure in reverse.
(Pass the cords under the ribs as shown.)
2
3
1
4
6
4
5
5
6
5
6
1
4
4
1
2
3
4
www.promelectroavtomat.ru
To Next Page
Loading...
