Janome MC9500 - Replacing Touch Panel (LCD); To remove:; To attach:

24
MC 9500
Replacing Touch Panel (LCD)
To remove:
1 Remove the front cover. (See page 6)
2 Pull out the Printed circuit board F , LCD Harness
and Inverter and Touch panel connectors.
3 Remove Screws (4 pieces) and remove the touch
panel .
To attach:
5 Place the Touch panel and press it against the ribs
(A), (B), (C), press the (D) and (E) of the LCD fixing
plate bottom) to the Touch panel and tighten
screws .
6 Place the (F) and (G) of LCD Fixing plate (Top) to
the LCD, then tighten the screws.
7 Connect the connectors into the machine and attach the
front cover.
Fixing plate (Top)
Screw
Fixing plate (Bottom)
Printed circuit board F connector
LCD Harness
Inverter connector
Touch panel connector
Touch panel (Rear side)
4
5
6
7
2
8
2
1
1
2
2
22
(A)
(F)
(B)
(C)
(G)
(E)
(D)
3
7
6
1
3
6
4
5
8
8
3
1
2
3
4
5
6
7
8
8
www.promelectroavtomat.ru