Janome MC9500 - Adjusting Buttonhole Lever

28
MC 9500
SET
Main
Slave
Brightness
Foot UD Sensor Off
Read Card PH Sensor Aging
Solenoid BH Sensor Sew Test
Bobbin Foot Sensor 8 Adjust
DC1
SET
Main
Slave
DC1
BH Sensor
OK
H
Adjusting Buttonhole Lever
To adjust buttonhole lever:
1 Start up the machine in “Adjust Mode”. Turn the
power switch “ON” while pressing the Start/Stop button.
(Keep pressing the button until the LCD shows Adjusting
window.)
2 Press “BH Sensor” key on the touch panel.
3 Loosen screw (A) and move the BH lever guide ,
so that the screen shows “L” when the BH lever is
lowered. Then tighten Screw (A) .
4 Attach the BH Foot (R) and lower the BH lever .
5 Insert the 1.6 mm thickness gauge between the
slider and the spring holder to set the space at 1.6 mm.
6. Loosen Screw until the touch panel shows “H”.
7 Screw in the screw until the screen indication changes
from “H” to “L”.
8 Press “OK” key and turn the power switch “OFF”.
1
3
3
1
4
5
Screw (A)
Buttonhole lever guide
Buttonhole lever
Clearance: 1.6 mm
Screw
1
3
2
4
5
1
2
3
4
5
2
www.promelectroavtomat.ru