Jasic EVOLVE 200 - 3. Instructions for Mobile Application; 3.1 Remote Controls

EVOLVE 200 USER MANUAL
39
3. Instructions for MOBILE Application
3.1 REMOTE CONTROLS
MIG TORCH DIGITAL
(Optional:This chapter will be
effective when this accessory is selected)
TIG TORCH DIGITAL
(Optional:This chapter will be effective when this accessory is selected)
TIG PEDAL with ANALOG POTENTIOMETER
Regulation by pedal from minimum current setting, to the current set.
In synergic mode, the mini current setting is the mini of synergic program.
In manual mode, the mini current setting is the mini current of the machine.
For the connections details, contact the service center.
Top Button
+
sets the current
(or the voltage
in MIG manual)
Bottom Button - sets the current (or the voltage in MIG manual)
Right Button + Adjust the arc
length in synergic (or the wire
speed in MIG manual)
Left Button – Adjust the arc length
in synergic (or the wire speed in
MIG manual)
Top Button
Trigger
tig
+
sets the current
–
sets the current
Top Button
Trigger
tig