EasyManua.ls Logo

Jeep Compass 2020 - Page 102

Jeep Compass 2020
560 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
100 GETTING TO KNOW YOUR VEHICLE
NOTE:
The liftgate will not power open or close if the gear selector
is in gear or the vehicle speed is above 0 mph (0 km/h).
If anything obstructs the power liftgate while it is closing or
opening, the liftgate will automatically reverse to the closed
or open position, provided it meets sufficient resistance.
There are pinch sensors attached to the side of the liftgate
opening. Light pressure anywhere along these strips will
cause the liftgate to return to the open position.
If the power liftgate encounters multiple obstructions
within the same cycle, the system will automatically stop.
If this occurs, the liftgate must be opened or closed manu-
ally.
The power liftgate will not operate in temperatures below
−22°F (−30°C) or temperatures above 150°F (65°C). Be sure
to remove any buildup of snow or ice from the liftgate
before pushing any of the power liftgate switches.
If the liftgate is left open for an extended period of time, the
liftgate may need to be closed manually to reset power lift-
gate functionality.
Gas props support the liftgate in the open position.
However, because the gas pressure drops with tempera-
ture, it may be necessary to assist the props when opening
the liftgate in cold weather.
Before driving off, check the instrument cluster for a lift-
gate or door open message or warning indicator. Failure to
do this could result in unintentionally leaving the liftgate
open while driving.
If your liftgate is power closing and you put the vehicle in
gear, the liftgate will continue to power close. However,
vehicle movement may result in a detection of an obstruc-
tion.
If the electronic liftgate release handle is pushed with the
power liftgate is opening, the liftgate motor will disengage
to allow manual operation.
If the electronic liftgate release handle is pushed while the
power liftgate is closing, the liftgate will reverse to the full
open position.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 100

Table of Contents