Jeep Compass 2020 - Changing Lanesense Status; Parkview Rear Back up Camera

312 STARTING AND OPERATING
Changing LaneSense Status
The LaneSense system has settings to adjust the intensity of
the torque warning (Low/Medium/High) and the warning
zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system screen. Refer to
“Uconnect Settings” in “Multimedia” for further informa-
tion.
NOTE:
• The system will not apply torque to the steering wheel
whenever a safety system engages (anti-lock brakes, trac-
tion control system, electronic stability control, forward
collision warning, etc.).
• Use of the turn signals and Hazard Warning flashers also
suppresses the warnings.
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see an
on-screen image of the rear surroundings of your vehicle
whenever the gear selector is put into REVERSE. The image
will be displayed in the touchscreen display along with a
caution note to “check entire surroundings” across the top of
the screen. After five seconds this note will disappear. The
ParkView camera is located on the rear of the vehicle above
the rear license plate.
NOTE:
The ParkView Rear Back Up Camera has programmable
modes of operation that may be selected through the Ucon-
nect System. Refer to “Uconnect Settings” in “Multimedia”
for further information.
When the vehicle is shifted out of REVERSE (with camera
delay turned off), the rear camera mode is exited and the
previous screen appears again. When the vehicle is shifted
out of REVERSE (with camera delay turned on), the camera
image will continue to be displayed for up to 10 seconds after
shifting out of REVERSE unless the vehicle speed exceeds
8 mph (13 km/h), the vehicle is shifted into PARK or the
vehicle’s ignition is placed in the OFF position.
NOTE:
With Camera Delay turned on, the camera image can be
disabled via the Image Defeat (X) button on the touch screen
when the vehicle is shifted out of REVERSE.
When enabled, active guide lines are overlaid on the image
to illustrate the width of the vehicle and its projected backup
path based on the steering wheel position. A dashed center
line overlay indicates the center of the vehicle to assist with
parking or aligning to a hitch/receiver.
Different colored zones indicate the distance to the rear of
the vehicle.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 312