EasyManua.ls Logo

Jeep Compass 2020 - Rear Window Wiper;Washer

Jeep Compass 2020
560 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72 GETTING TO KNOW YOUR VEHICLE
The sensitivity of the system can be adjusted with the multi-
function lever. Wiper delay position one is the least sensitive,
and wiper delay position two is the most sensitive. Place the
wiper switch in the O (off) position when not using the system.
NOTE:
The Rain Sensing feature will not operate when the wiper
switch is in the low or high-speed position.
The Rain Sensing feature may not function properly when
ice, or dried salt water is present on the windshield.
Use of Rain-X or products containing wax or silicone may
reduce Rain Sensing performance.
The Rain Sensing feature can be turned on and off using
the Uconnect System, refer to “Uconnect Settings in
“Multimedia” for further information.
The Rain Sensing system has protection features for the
wiper blades and arms, and will not operate under the
following conditions:
Change In Ignition Position If the vehicle is in Rain
Sensing mode and the ignition is cycled from OFF to ON,
the auto wiper will be suppressed until vehicle speed is
greater than 3 mph (5 km/h), or the wiper switch is moved
out of and back into the Intermittent wipe position.
Transmission In NEUTRAL Position The Rain Sensing
system will not operate if the NEUTRAL gear is selected at
speeds of 3 mph (5 km/h) or less unless the wiper switch
is moved or the gear selector is moved out of NEUTRAL.
Remote Start Mode Inhibit On vehicles equipped with
Remote Starting system, Rain Sensing wipers are not oper-
ational when the vehicle is in the remote start mode. Once
the operator is in the vehicle and has placed the ignition
switch in the ON/RUN position, Rain Sensing wiper oper-
ation can resume, if it has been selected, and no other
inhibit conditions (mentioned previously) exist.
Rear Window Wiper/Washer
The rear wiper/washer controls are located on the wind-
shield wiper/washer lever on the right side of the steering
column. The rear wiper/washer is operated by rotating a
switch, located at the middle of the lever.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 72

Table of Contents

Related product manuals