STARTING AND OPERATING 249
Gear Selector
To shift the gears, fully press the clutch pedal and place the
gear selector into the desired gear position (the diagram for
the engagement of the gears is displayed on the handle of the
selector).
To engage REVERSE gear from the NEUTRAL position, lift
the REVERSE ring, located below the knob and move the
gear selector all the way left and then forward.
Shift Pattern
Shifting
Fully press the clutch pedal before shifting gears. As you
release the clutch pedal, lightly press the accelerator pedal.
You should always use first gear when starting from a
standing position.
5
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 249
To Next Page
Loading...
