140 GETTING TO KNOW YOUR INSTRUMENT PANEL
White Indicator Lights
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON, but not armed,
the LaneSense indicator light illuminates solid
white. This occurs when only left, right, or neither
lane line has been detected. If a single lane line is detected,
the system is ready to provide only visual warnings if an
unintentional lane departure occurs on the detected lane
line.
Refer to “LaneSense — If Equipped” in “Starting And Oper-
ating” for further information.
Hill Descent Control (HDC) Indicator Light — If Equipped
This indicator shows when the Hill Descent Control
(HDC) feature is turned on. The lamp will be on
solid when HDC is armed. HDC can only be armed
when the transfer case is in the “4WD LOW” position and the
vehicle speed is less then 30 mph (48 km/h). If these condi-
tions are not met while attempting to use the HDC feature,
the HDC indicator light will flash on/off.
Cruise Control Ready Indicator Light — If Equipped With
A Premium Instrument Cluster
This light will turn on when the speed control has
been turned on, but not set. Refer to “Speed Control —
If Equipped” in “Starting And Operating” for further
information.
Cruise Control SET Indicator Light — If Equipped With
Base Instrument Cluster
This indicator light will illuminate when the speed
control is set.
Refer to “Speed Control — If Equipped” in “Starting And
Operating” for further information.
Blue Indicator Lights
High Beam Indicator Light
This indicator light will illuminate to indicate that
the high beam headlights are on. With the low
beams activated, push the multifunction lever
forward (toward the front of the vehicle) to turn on
the high beams. Pull the multifunction lever rearward
(toward the rear of the vehicle) to turn off the high beams. If
the high beams are off, pull the lever toward you for a tempo-
rary high beam on, “flash to pass” scenario.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 140
To Next Page
Loading...
