270 STARTING AND OPERATING
2. The “STOP/START OFF” message will appear in instru-
ment cluster display. Refer to “Instrument Cluster
Display” in “Getting To Know Your Instrument Panel”
for further information.
3. At the next vehicle stop (after turning off the Stop/Start
system) the engine will not be stopped.
4. The Stop/Start system will reset itself back to an ON
condition every time the ignition is turned off and back
on.
To Manually Turn On The Stop/Start System
Push the Stop/Start OFF switch (located on the switch bank).
The light on the switch will turn off.
System Malfunction
If there is a malfunction in the Stop/Start system, the system
will not shut down the engine. A “SERVICE STOP/START
SYSTEM” message will appear in the instrument cluster
display. Refer to “Display” in “Getting To Know Your
Instrument Panel” for further information.
If the “SERVICE STOP/START SYSTEM” message appears
in the instrument cluster display, have the system checked
by your authorized dealer.
SPEED CONTROL — IF EQUIPPED
When engaged, the Speed Control takes over accelerator
operations at speeds greater than 20 mph (32 km/h).
The Speed Control buttons are located on the right side of the
steering wheel.
Speed Control Buttons
1 — On/Off
2 — SET (+)/Accel
3 — RES/Resume
4 — SET (-)/Decel
5 — CANC/Cancel
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 270
To Next Page
Loading...
