138 GETTING TO KNOW YOUR INSTRUMENT PANEL
Yellow Indicator Lights
4WD Low Indicator Light — If Equipped
This light alerts the driver that the vehicle is in the
four-wheel drive LOW mode. The front and rear
driveshafts are mechanically locked together forcing
the front and rear wheels to rotate at the same speed. Low
range provides a greater gear reduction ratio to provide
increased torque at the wheels.
Refer to “Four-Wheel Drive Operation — If Equipped” in
“Starting And Operating” for further information on
four-wheel drive operation and proper use.
4WD Lock Indicator Light
This light alerts the driver that the vehicle is in the
four-wheel drive LOCK mode. The front and rear
driveshafts are mechanically locked together,
forcing the front and rear wheels to rotate at the same speed.
Refer to “Four-Wheel Drive Operation” in “Starting And
Operating” for further information on four-wheel drive
operation and proper use.
Forward Collision Indicator Light — If Equipped
This telltale will turn on to warn you of a possible
collision with the vehicle in front of you.
Forward Collision Warning Off Indicator Light — If
Equipped
This indicator light illuminates to indicate that
Forward Collision Warning is off.
Immobilizer Fail / VPS Electrical Alarm Indicator Light
This telltale will illuminate when the vehicle security
alarm system has detected an attempt to break into
the vehicle.
NOTE:
After cycling the ignition to the ON/RUN position, the
Vehicle Security Warning Light could illuminate if a
problem with the system is detected. This condition will
result in the engine being shut off after two seconds.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 138
To Next Page
Loading...
