Jeep Compass 2020 - To Manually Turn off the Stop;Start System

STARTING AND OPERATING 269
Conditions That Will Cause The Engine To Start Automat-
ically While In Autostop Mode:
• The transmission selector is moved out of DRIVE (D).
• To maintain cabin temperature comfort.
• HVAC is set to full defrost mode.
• HVAC system temperature or fan speed is manually
adjusted.
• Battery voltage drops too low.
• Low brake vacuum (e.g. after several brake pedal applica-
tions).
• Stop/Start OFF switch is pressed.
• A Stop/Start system error occurs.
• 4WD system is put into 4WD LOW mode.
Conditions That Force An Application Of The Electric Park
Brake While In Autostop Mode:
• The drivers door is open and brake pedal released.
• The drivers door is open and the drivers seat belt is
unbuckled.
• The engine hood has been opened.
• A Stop/Start system error occurs.
If the Electric Park Brake is applied with the engine off, the
engine may require a manual restart and the electric park
brake may require a manual release (depress brake pedal
and press Electric Park Brake switch). Refer to “Instrument
Cluster Display” in “Getting To Know Your Instrument
Panel” for further information.
To Manually Turn Off The Stop/Start System
1. Push the Stop/Start OFF switch (located on the switch
bank). The light on the switch will illuminate.
Stop/Start OFF Switch
5
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 269