EasyManua.ls Logo

Jeep Compass 2020 - Lanesense - if Equipped; Lanesense Operation

Jeep Compass 2020
560 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
304 STARTING AND OPERATING
LANESENSE — IF EQUIPPED
LaneSense Operation
The LaneSense system is operational at speeds above 37 mph
(60 km/h) and below 112 mph (180 km/h). The LaneSense
system uses a forward looking camera to detect lane mark-
ings and measure vehicle position within the lane bound-
aries.
When both lane markings are detected and the driver unin-
tentionally drifts out of the lane (no turn signal applied), the
LaneSense system provides a haptic warning in the form of
torque applied to the steering wheel, as well as a visual
warning in the instrument cluster display, to prompt the
driver to remain within the lane boundaries.
The driver may manually override the haptic warning by
applying torque into the steering wheel at any time.
When only a single lane marking is detected and the driver
unintentionally drifts across the lane marking (no turn signal
applied), the LaneSense system provides a visual warning
through the instrument cluster display to prompt the driver
to remain within the lane. When only a single lane marking
is detected, a haptic (torque) warning will not be provided.
Before using ParkSense, it is strongly recommended
that the ball mount and hitch ball assembly is discon-
nected from the vehicle when the vehicle is not used for
towing. Failure to do so can result in injury or damage
to vehicles or obstacles because the hitch ball will be
much closer to the obstacle than the rear fascia when
the loudspeaker sounds the continuous tone. Also, the
sensors could detect the ball mount and hitch ball
assembly, depending on its size and shape, giving a
false indication that an obstacle is behind the vehicle.
CAUTION!
ParkSense is only a parking aid and it is unable to
recognize every obstacle, including small obstacles.
Parking curbs might be temporarily detected or not
detected at all. Obstacles located above or below the
sensors will not be detected when they are in close
proximity.
The vehicle must be driven slowly when using Park-
Sense in order to be able to stop in time when an
obstacle is detected. It is recommended that the driver
looks over his/her shoulder when using ParkSense.
WARNING! (Continued)
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 304

Table of Contents

Related product manuals