GETTING TO KNOW YOUR INSTRUMENT PANEL 139
Green Indicator Lights
LaneSense Indicator Light — If Equipped
The LaneSense indicator light illuminates solid
green when both lane markings have been detected
and the system is “armed” and ready to provide
visual and torque warnings if an unintentional lane depar-
ture occurs.
Refer to “LaneSense — If Equipped” in “Starting And Oper-
ating” for further information.
Park/Headlight On Indicator Light
This indicator light will illuminate when the park
lights or headlights are turned on.
Front Fog Indicator Light — If Equipped
This indicator light will illuminate when the front
fog lights are on.
Turn Signal Indicator Lights
When the left or right turn signal is activated, the
turn signal indicator will flash independently and
the corresponding exterior turn signal lamps will
flash. Turn signals can be activated when the multifunction
lever is moved down (left) or up (right).
NOTE:
• A continuous chime will sound if the vehicle is driven
more than 1 mile (1.6 km) with either turn signal on.
• Check for an inoperative outside light bulb if either indi-
cator flashes at a rapid rate.
Cruise Control SET Indicator Light — If Equipped With A
Premium Instrument Cluster
This indicator light will illuminate when the speed
control is set to the desired speed. Refer to “Speed
Control — If Equipped” in “Starting And Oper-
ating” for further information.
Stop / Start Active Indicator Light — If Equipped
This indicator light will illuminate when the Stop/
Start function is in “Autostop” mode.
Automatic High Beam Indicator Light — If Equipped
This indicator shows that the automatic high beam
headlights are on.
3
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 139
To Next Page
Loading...
