Jeep Compass 2020 - Turning Lanesense on or off

STARTING AND OPERATING 305
NOTE:
When operating conditions have been met, the LaneSense
system will monitor if the driver’s hands are on the steering
wheel and provide an audible and visual warning to the
driver when the driver’s hands are not detected on the
steering wheel. The system will cancel if the driver does not
return their hands to the wheel.
Turning LaneSense On Or Off
The default status of LaneSense is “Off”.
The LaneSense button is located on the switch panel
below the Uconnect display.
To turn the LaneSense system on, push the LaneSense button
to turn the system on (LED turns off). A “LaneSense On”
message is shown in the instrument cluster display.
Lane Sense On Message
To turn the LaneSense system off, push the LaneSense button
once to turn the system off (LED turns on).
NOTE:
The LaneSense system will retain the last system state on or
off from the last ignition cycle when the ignition is changed
to the ON/RUN position.
5
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 305