GETTING TO KNOW YOUR VEHICLE 51
Easy Entry/Exit Seat — If Equipped
This feature provides automatic driver seat positioning to
enhance driver mobility when entering and exiting the
vehicle.
The distance the driver seat moves depends on where you
have the driver seat positioned when you place the vehicle’s
ignition in the OFF position.
• When you place the vehicle’s ignition in the OFF position,
the driver seat will move about 2.4 inches (60 mm) rear-
ward if the driver seat position is greater than or equal to
2.7 inches (67.7 mm) forward of the rear stop. The seat will
return to its previously set position when you place the
vehicle’s ignition in the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the
driver seat position is less than 0.9 of an inch (22.7 mm)
forward of the rear stop. At this position, there is no benefit
to the driver by moving the seat for Easy Exit or Easy
Entry.
Each stored memory setting will have an associated Easy
Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when the vehicle
is delivered from the factory. The Easy Entry/Exit feature is
enabled (or later disabled) through the programmable
features in the Uconnect system.
Refer to “Uconnect Settings/Customer Programmable
Features” in “Multimedia” for further information.
Front Heated Seats — If Equipped
The front heated seats control buttons are located within the
Uconnect system. You can gain access to the control buttons
through the climate screen or the controls screen.
• Press the heated seat button once to turn the HI setting
on.
• Press the heated seat button a second time to turn the
LO setting on.
• Press the heated seat button a third time to turn the
heating elements off.
2
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 51
To Next Page
Loading...
