50 GETTING TO KNOW YOUR VEHICLE
To program your key fob, perform the following:
1. Place the vehicle’s ignition in the OFF position.
2. Select the desired memory profile (1) or (2).
NOTE:
If a memory profile has not already been set, refer to
"Programming The Memory Feature" in this section for
instructions on how to set a memory profile.
3. Push and release the set (S) button on the memory switch,
then within five seconds push and release the button
labeled (1) or (2) accordingly. “Memory Profile Set” (1 or 2)
will display in the instrument cluster display.
4. Push and release the lock button on the key fob within
10 seconds.
NOTE:
Your key fob can be unlinked to your memory settings by
pushing the set (S) button, followed by pushing the unlock
button on the key fob within 10 seconds.
Memory Position Recall
NOTE:
The vehicle must be in PARK (P) to recall memory positions.
If a recall is attempted when the vehicle is not in PARK, a
message will display in the instrument cluster display.
• To recall the memory settings for driver one, push memory
button (1) or the unlock button on the key fob linked to
memory position 1.
• To recall the memory settings for driver two, push
memory button (2) or the unlock button on the key fob
linked to memory position 2.
A recall can be canceled by pushing any of the memory
buttons (S, 1, or 2) during a recall. When a recall is canceled,
the driver seat will stop moving. A delay of one second will
occur before another recall can be selected.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 50
To Next Page
Loading...
