Jeep Compass 2020 - Page 51

GETTING TO KNOW YOUR VEHICLE 49
Programming The Memory Feature
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase an existing profile
from memory.
1. Place the vehicle’s ignition in the ON position.
2. Adjust all memory profile settings to desired preferences
(i.e., seat and radio station presets).
3. Push and release the set (S) button on the memory switch,
then push memory button (1) within five seconds. The
instrument cluster display will display which memory
position is being set.
If desired, a second memory profile can be stored into
memory as follows:
1. Place the vehicle’s ignition in the ON position.
2. Adjust all memory profile settings to desired preferences
(i.e., seat and radio station presets).
3. Push and release the set (S) button on the memory switch,
then push memory button (2) within five seconds. The
instrument cluster display will display which memory
position is being set.
NOTE:
• Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
• To set a memory profile to your key fob, refer to “Linking
And Unlinking The Remote Keyless Entry Key Fob To
Memory” in this section.
Linking And Unlinking The Remote Keyless Entry Key
Fob To Memory
Your remote keyless entry key fob can be programmed to
recall one of two pre-programmed memory profiles with a
push of the unlock button on the key fob.
NOTE:
Before programming your key fob you must select the
“Memory Linked To FOB” feature through the Uconnect
system screen. Refer to “Uconnect Settings” in “Multimedia”
for further information.
2
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 49