134 GETTING TO KNOW YOUR INSTRUMENT PANEL
Electronic Stability Control (ESC) OFF Warning Light —
If Equipped
This warning light indicates the Electronic Stability
Control (ESC) is off.
Each time the ignition is turned to ON/RUN or
ACC/ON/RUN, the ESC system will be on, even if it was
turned off previously.
Fuel Cutoff Warning Light — If Equipped
This warning light will illuminate after an accident
has occurred, and the system has shut the fuel off.
LaneSense Warning Light — If Equipped
The LaneSense Warning Light will be solid yellow
when the vehicle is approaching a lane marker. The
warning light will flash when the vehicle is crossing
the lane marker.
Refer to “LaneSense — If Equipped” in “Starting And Oper-
ating” for further information.
Service LaneSense Warning Light — If Equipped
This warning light will illuminate when the Lane-
Sense system is not operating and requires service.
Please see an authorized dealer.
Low Coolant Level Warning Light
This telltale will turn on to indicate the vehicle
coolant level is low.
Low Fuel Warning Light
Depending on whether the tank size is 13.5 gal (51 L)
or 15.8 gal (60 L), the Low Fuel Indicator Light will
turn on when the fuel level goes below 1.5 gal (5.6 L)
or 1.7 gal (6.6 L) respectively.
Low Washer Fluid Warning Light — If Equipped
This warning light will illuminate when the wind-
shield washer fluid is low.
Engine Check/Malfunction Indicator Warning Light (MIL)
The Engine Check/Malfunction Indicator Light
(MIL) is a part of an Onboard Diagnostic System
called OBD II that monitors engine and automatic
transmission control systems. This warning light will illumi-
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 134
To Next Page