38 GETTING TO KNOW YOUR VEHICLE
DO NOT Grab The Door Handle When Locking
NOTE:
• After pushing the door handle button, you must wait two
seconds before you can lock or unlock the doors, using
either Passive Entry door handle. This is done to allow you
to check if the vehicle is locked by pulling the door handle
without the vehicle reacting and unlocking.
• If Passive Entry is disabled using the Uconnect System, the
key protection described in “Preventing Inadvertent
Locking of Passive Entry Key Fob In Vehicle” remains
active/functional.
• The Passive Entry system will not operate if the key fob
battery is depleted.
The vehicle doors can also be locked by using the lock button
located on the vehicle’s interior door panel.
2020_JEEP_MP_OM_USA=GUID-E8C7E66B-DF9E-40BA-9B4A-03D9C7E22684=1=en=.backup.book Page 38
To Next Page
Loading...
