Page 83 of 97
12 – TOOLS
______________________________________________________________________________________________
¾ Put the three-phase feeding plug (380V red) into the kit proper socket
Use:
¾ Make sure the machine is stabilized
¾ Turn the feeding key switch located on the switchboard on position 380V (3.1)
¾ Start the engine by means of the special black push button and turn the key switch on
position 1 or 2 – leave the key switch in the position that implies the engine correct rotation
(clockwise rotation as indicated by the arrow).
Check at all times that the engine rotation is clockwise as
indicated by the arrow on the engine block
¾ To stop the engine, press the red emergency mushroom push button or turn the key
switch on the 0 position
In case the engine doesn’t start:
- check that the emergency push button is deactivated (to unlock
it, turn the ring nut)
Transfer by truck can only be done by exploiting the battery or the
diesel feeding
When disconnecting the kit hydraulic feeding in order to remove the
kit from the machine, first disconnect line 2 and then line 1. A
different procedure might generate dangers deriving from high-
pressure fluid jets!!!
To Next Page
Loading...
Need help?
General
