9
Tailstock
The tailstock (L) slides on a v-way and can be
locked at any location by a clamping lever. The
tailstock has a heavy duty quill with a No. 4 Morse
Taper and etched graduation scale. The tailstock
can be offset for taper cutting.
Leadscrewandfeedrod
The leadscrew (M) and feed rod (N) are mounted
on the front of the machine bed. They are
connected to the gearbox at the left and are
supported by bearings on both ends.
Spindledirectioncontrolaxle(O)
Spindle rotation can be reversed by simply moving
the control lever (P) mounted at the right of the
carriage. (Allow spindle to come to a stop before
reversing.)
ThreadChaser(Q)
Simplifies the process of setting leadscrew/carriage
positions in relation to the workpiece, by indicating
the point on the leadscrew where the half nut can
be reengaged to continue threading.
Microcarriagestop(P)
A dial with incremental scale offers precise
positioning of the stop.
Steadyrest(S)
The steady rest serves as a support for shafts on
the free tailstock end. The steady rest is mounted
on the bedway and secured from below with a bolt,
nut and locking plate.
Followrest(T)
The traveling follow rest is mounted to the saddle,
and thus follows the movement of the turning tool.
Only two fingers are required as the place of the
third is taken by the turning tool. The follow rest is
used for turning operations on long, slender work
pieces. It prevents the work piece from flexing
under the pressure of the cutting tool.
Worklamp(U)
Adjustable halogen lamp with independent on/off
switch.
Coolantn ozzle(V)
Fully adjustable gooseneck; flow is regulated
through a valve lever at its base.
Footbrake(W)
Activates a braking strap at the motor for
emergency stopping of all lathe functions.
Chuckguard(X)
To Next Page
Loading...
Need help?
General
