radio control system
EN
9. Keep all moving parts clean and free of dust or fine debris that
might damage the mechanical parts of the radio.
10. Do not cover the antenna of the transmitter with any objects,
especially metal, carbon or parts of the human body (for
example: hand), etc. The radiation pattern from the antenna will
be shielded and provide poor connection to your model.
11. Never repair, re-install, or exchange the internal memory SD
card for other type.
12. Avoid extreme temperatures as they can cause damage to the
sensitive internal SD card.
13. Always perform a ground range check prior to your initial flight.
7.3 Pre-Flight Checks
1. Always verify the correct position of the switches, and the
gimbals, prior turning ON your transmitter. Turn on the
transmitter first, then receiver. JETI transmitters use "Model
Checking". This safety is designed so that the model memory
stores the unique serial number of the receiver that has already
been assigned to model. When the transmitter establishes
communication with the receiver and the serial number does
not match the number stored in the current model’s setup, the
transmitter displays a warning. You will then be able to accept
the change or reject the change. If you accept the change, the
transmitter stores the new receiver number into the model’s
setup and begins transmitting. If you reject the change, the
transmitter will not communicate with the receiver and you will
be allowed to select another model.
This product may be used for model airplane or surface (boat, car,
robot) use only. It is not intended for use in any other application
than control of the models for hobby, sport and recreational
purposes.
7.4 Application
2. Perform a ground range check before each day’s flying session.
3. Check the battery voltage on both the transmitter and the
receiver battery packs.
4. Check all channel assignments, trim, mixes, and the correct
direction of movement for your flight surfaces.
5. Set motor/engine kill switch and test the power train.
FCC Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
7.5 FCC information
77
www.modellmarkt24.ch
To Next Page